BMW ICOM

Recently, there are many customers who have reflected,the following tips appear when testing some Mercedes-Benz cars with V2018.09 MB STAR C4 SD Connect Compact Diagnosis tool: We first checked the hardware of MB STAR C4/C5 and found that the hardware works normally. The problem should be in the software section. One of the customers in Hong Kong reported that after the software upgrade to V2018.09, the Mercedes-Benz C-series car could not be connected, and the same prompt appeared above. Model of his car: Mercedes-Benz C320 chassis W204 2015. We looked at the diagnostic interface provided by the customer and found that there is a hardware icon for MB STAR C6 in the upper right corner of the xentry software interface, as follows: It turns out that the customer has set the hardware mode error to C6 mode. When the customer uses the Mercedes-Benz diagnostic tool MB STAR C4 or C5, the corresponding hardware mode must be set to C4 in the software. Your MB STAR...

If ICOM A2 clone with WiFi now I have seen that the most difference between an original BMW ICOM A2 and a clone is that the original has wifi capability, whereas the clone does not. Today the Eobd2 customer services tell me that their BMW ICOM A2+b+c diagnostic & programming tool now has wifi capability. And I saw a lot of people comment ICOM A2 clones with wifi capability that work reliably. On the more technical side, I’ve encountered through the grape vine that the new units that they add as a wifi Module is, “a Sparklan WMIA-199N based on an ATHEROS MIMO chip.” Apparently it is possible to, “get a fully functional Mini PCI port between the layers”(of the ICOM A2’s internal circuit boards that would allow for incorporating a wifi mod). You can get some information of BMW ICOM A2+B+C below: BMW ICOM A2+B+C Functions: A2 – OBD diagnostic supporting MOST, D-CAN and K-CAN protocols B – Diagnostic via most bus, and have connection to A-interface via USB connect...